Faceplate Interfaces - Avaya S8400 Installing & Configuring

Chapter 8: Installation verification

Faceplate interfaces

The TN8400AP Server maintenance complex has the following faceplate interfaces
(Figure 6: TN8400AP Server faceplate
TN8400 circuit pack failure LED
- This LED is on during a turn-on sequence and during a reset. When the turn-on
sequence or the reset is complete and no failures exists, the LED turns off.
- When lit, this LED indicates that a failure exists on the TN8400AP circuit pack.
Shutdown button
Communication Manager Processor Complex remains shutdown until power is removed
and then reapplied. This switch gracefully turns off the operating system and the file
system. Data is preserved.
OK to remove circuit pack LED
- Off indicates that the system is operational.
- Flashing indicates that the shutdown is in progress.
- Solid indicates that you can safely remove the TN8400AP Server circuit pack from the
carrier or turn off the carrier where the TN8400AP resides.
Major alarm status LED
Services Ethernet link status LED
Ethernet link. The LED is on when the link is in service. The LED flashes any time that data
transitions are detected.
Services RJ45 connection to the Services laptop computer
provides access to a single 10/100 BaseT Ethernet interface by an RJ-45 connector. This
port is connected, using a cross-over cable, to the Services computer to provide on-site
Services access to the system.
Compact flash in use LED
being accessed.
Compact flash slot
translations and application data.
USB port for the USB CD-ROM drive
equipment such as a USB CD-ROM or DVD-ROM for software and firmware updates. Do
not connect the modem to this port.
Server active LED
- Is On when the Maintenance Processor detects that the primary application of the
Communication Manager Processor is loaded and running.
- Is Off during a power-on reset or when the system is shutting down.
- Flashes when a diagnostic test or self test is running.
62
Installing and Configuring the Avaya S8400 Server
on page 61):
(red)
- Press the shutdown button for 2 seconds to start a shutdown. The
- This green LED gives a status of the shutdown process.
- This red LED indicates that a major alarm condition is detected.
- This green LED shows the status of the Services
- This yellow LED indicates that the compact flash memory is
- This slot is an interface for compact flash media for storage of
- This port is used to communicate with peripheral
- This green LED:
computer- This Ethernet port
January 2008