Chapter 6: IP interface configuration
This chapter covers the following tasks:
SIPI address configuration
Programming the SIPI for static addressing
Setting the VLAN and diffserv parameters
Verifying connectivity to the server
Verifying that the SIPI is translated
Upgrading the SIPI firmware version (if necessary)
Enabling control of the SIPI
Verifying the license status
You must program the TN8412AP Server IP Interface (SIPI) so that the system does not enter
No License Mode.
SIPI address configuration
The SIPI circuit pack usually uses static IP addressing only. See
addressing
on page 45.
Programming the SIPI for static addressing
You administer the static IP address for the circuit pack directly through the Ethernet port
connection on the faceplate. See
Installing and Configuring the Avaya S8400 Server
on page 45
on page 45
on page 48
on page 49
on page 50
on page 50
on page 50
Figure
4.
on page 50
Programming the SIPI for static
45
January 2008