Using The Sat Command Line Prompt; Logins For Avaya Technicians And Businesspartners - Avaya S8400 Installing & Configuring

Using the SAT command line prompt

Use a remote Secure Shell (SSH) or terminal emulation session to access the Communication
Manager SAT command line prompt.
Type of connection
Using SAT with SSH:
Using SAT with Terminal
Emulation

Logins for Avaya technicians and BusinessPartners

Avaya field technicians and BusinessPartners must use a Services login such as craft or
dadmin to perform initial configuration and upgrades. An Avaya field technician can use a
unique password that is assigned to the customer system.
After the Avaya authentication file is installed, Avaya Communication Manager has a password
for the craft login that is unique to the customer system and available when you are connected
directly to the server. If the system is configured without ASG, then all security authentications
are through passwords. If ASG is turned on, then all authentication is through ASG except for
logins over the service port which require a password. The revised password is recorded by
RFA and is obtained from ASG Conversant at 1-800-248-1234 or 1-720-444-5557.
Customers can set up their own logins to access Avaya servers. You must have superuser
permission to create or change logins and passwords. NOTE: do not start login IDs with a
number. For more information, see the Avaya Communication Manager Basic Administration
Quick Reference (03-300363).
Installing and Configuring the Avaya S8400 Server
See Accessing the command line interface of the server with
SSH on page 69.
To use a command line interface in a terminal emulation window,
open your terminal emulation application. Configure the terminal
emulation program port settings as follows:
Speed: 115200 baud or 9600 baud if you use a serial
modem connection
No parity
8 data bits
1 stop bit
No flow control
NOTE: Avaya Native Configuration Manager, Avaya Terminal
Emulation, and HyperTerminal are the only terminal emulation
programs that Avaya supports.
Using the SAT command line prompt
Procedure
75
January 2008