Configuring A Protocol-Based Vlan; Configuration Task List; Configuring A Protocol Template For A Protocol-Based Vlan - 3Com WX3000 Series Operation Manual

For the command of configuring a port link type (port link-type) and the command of allowing packets
of certain VLANs to pass through a port (port trunk permit), refer to the section of configuring Ethernet
ports in the "Port Basic Configuration" part of this document.

Configuring a Protocol-Based VLAN

Configuration Task List

Complete the following tasks to configure protocol-based VLAN:

Configuring a Protocol Template for a Protocol-Based VLAN

Associating a Port with a Protocol-Based VLAN
Displaying and Maintaining Protocol-Based VLAN
Configuring a Protocol Template for a Protocol-Based VLAN
Configuration prerequisites
Create a VLAN before configuring the VLAN as a protocol-based VLAN.
Configuration procedure
Follow these steps to configure the protocol template for a VLAN:
To do...
Enter system view
Enter VLAN view
Configure the protocol template
for the VLAN
When configuring a protocol template for a protocol-based VLAN, use the at, ip or ipx keyword to
configure a standard template to match AppleTalk, IP, and IPX packets respectively, and use the mode
keyword to configure a user-defined template.
Task
Use the command...
system-view
vlan vlan-id
protocol-vlan [ protocol-index ]
{ at | ip | ipx { ethernetii | llc |
raw | snap } | mode
{ ethernetii etype etype-id | llc
dsap dsap-id ssap ssap-id |
snap etype etype-id } }
2-5
Remarks
Required
Required
Optional
Remarks
—
—
Required
By default, no protocol template
is configured for the VLAN.