Qos Profile Configuration; Qos Profile Configuration Task List; Configuring A Qos Profile; Applying A Qos Profile - 3Com WX3000 Series Operation Manual

QoS Profile Configuration

QoS Profile Configuration Task List

Complete the following tasks to configure a QoS profile:

Configuring a QoS Profile

Applying a QoS Profile

Applying a QoS Profile
Configuring a QoS Profile
Configuration prerequisites
The ACL rules used for traffic classification are defined. Refer to the ACL module of this manual for
information about defining ACL rules.
The type and number of actions in the QoS profile are specified.
Configuration procedure
Follow these steps to configure a QoS profile:
To do...
Enter system view
Create a QoS profile and
enter QoS profile view
Configure traffic policing
Configure packet filtering
Configure priority marking
Applying a QoS Profile
You can configure to apply a QoS profile dynamically or simply apply a QoS profile manually.
Configuration prerequisites
To configure to apply a QoS profile dynamically, make sure 802.1x is enabled both globally and on
the port, and the authentication mode is determined. For information about 802.1x, refer to the
802.1x and System Guard module of this manual.
To apply a QoS profile manually, make sure the port to which the QoS profile is to be applied is
determined.
The QoS profile to be applied is determined.
Task
Use the command...
system-view
qos-profile profile-name
traffic-limit inbound acl-rule
target-rate [ conform con-action ]
[ exceed exceed-action ]
[ meter-statistic ]
packet-filter inbound acl-rule
traffic-priority inbound acl-rule
{ dscp dscp-value | cos cos-value }
Required
Optional
Optional
2-2
Remarks
Remarks
—
—
Optional
Optional
Refer to the ACL module of
this manual for information
about packet filtering.
Optional