Basic System Configuration And Debugging; Basic System Configuration - 3Com WX3000 Series Operation Manual

2

Basic System Configuration and Debugging

Basic System Configuration

Follow these steps to perform basic system configuration:
To do...
Set the current date and
time of the system
Set the local time zone
Set the name and time
range of the summer
time
Enter system view from
user view
Set the system name of
the device
Return from current
view to lower level view
Return from current
view to user view
Use the command...
clock datetime
HH:MM:SS
{ YYYY/MM/DD |
MM/DD/YYYY }
clock timezone
zone-name { add |
minus } HH:MM:SS
clock summer-time
zone_name { one-off |
repeating } start-time
start-date end-time
end-date offset-time
system-view
sysname sysname
quit
return
2-1
Remarks
Required
Execute this command in user view.
The default value is 23:55:00 04/01/2000
when the system starts up.
Optional
Execute this command in user view.
By default, it is the UTC time zone.
Optional
Execute this command in user view.
When the system reaches the specified
start time, it automatically adds the
specified offset to the current time, so as
to toggle the system time to the summer
time.
When the system reaches the specified
end time, it automatically subtracts the
specified offset from the current time, so
as to toggle the summer time to normal
system time.
—
Optional
By default, the name is device.
Optional
If the current view is user view, you will quit
the current user interface.
Optional
The composite key Ctrl+Z has the same
effect with the return command.