Configuring Vlan-Based Mirroring - 3Com WX3000 Series Operation Manual

Configuration prerequisites
The MAC address to be matched is determined.
The destination port is determined.
Configuration procedure
Follow these steps to configure MAC-based mirroring:
To do...
Enter system view
Create a local or remote source
mirroring group
Configuring MAC-Based
Mirroring
Configure the destination port
for the mirroring group
Configuration example
Configure MAC-based mirroring to mirror packets whose source/destination MAC addresses match
000f-e20f-0101 to port GigabitEthernet 1/0/2 on the local device.
Configuration procedure:
<device> system-view
[device] mac-address static 000f-e20f-0101 interface Gigabitethernet 1/0/1 vlan 2
[device] mirroring-group 1 local
[device] mirroring-group 1 mirroring-mac 000f-e20f-0101 vlan 2
[device] mirroring-group 1 monitor-port GigabitEthernet 1/0/2

Configuring VLAN-Based Mirroring

You can configure VLAN-based mirroring for a remote source mirroring group to implement the
VLAN-based remote mirroring function.
Configuration prerequisites
The VLAN to be monitored is determined.
The destination port is determined.
Use the command...
system-view
mirroring-group group-id
{ local | remote-source }
mirroring-group group-id
mirroring-mac mac vlan
vlan-id
mirroring-group group-id
monitor-port monitor-port-id
1-8
Remarks
—
Required
Required
Required
Note that you need not
configure the destination port
on the source switch when
configuring MAC-based remote
mirroring.