Configuring Leaf Nodes - 3Com WX3000 Series Operation Manual

To do...
Enter system view
Enable MSTP
Enter Ethernet port view
Disable MSTP on the
port
You are not recommended to enable MSTP on GigabitEthernet 1/0/29 on the switching engine of the
WX3024, GigabitEthernet 1/0/11 on the switching engine of the WX3010 or GigabitEthernet 1/0/9 on
the switching engine of the WX3008.
Other MSTP-related settings can take effect only after MSTP is enabled on the device.
Configuration example
# Enable MSTP on the device and disable MSTP on GigabitEthernet 1/0/1.
1) Perform this configuration in system view
<device> system-view
[device] stp enable
[device] stp interface GigabitEthernet1/0/1 disable
2) Perform this configuration in Ethernet port view
<device> system-view
[device] stp enable
[device] interface GigabitEthernet1/0/1
[device-GigabitEthernet1/0/1] stp disable

Configuring Leaf Nodes

Complete the following tasks to configure a leaf node:
Enabling MSTP
Configuring an MST Region
Use the command...
system-view
stp enable
interface interface-type
interface-number
stp disable
Task
—
Required
MSTP is disabled by default.
—
Optional
By default, MSTP is enabled on all ports after
you enable MSTP in system view.
To enable a device to operate more flexibly,
you can disable MSTP on specific ports. As
MSTP-disabled ports do not participate in
spanning tree calculation, this operation saves
CPU resources of the device.
Required
To prevent network topology jitter caused by other
related configurations, you are recommended to
enable MSTP after performing other configurations.
Required
1-29
Remarks
Remarks