Assigning An Acl To A Port; Displaying And Maintaining Acl - 3Com WX3000 Series Operation Manual

Assigning an ACL to a Port

Configuration prerequisites
Before applying ACL rules to a VLAN, you need to define the related ACLs. For information about
defining an ACL, refer to
Configuration procedure
Follow these steps to apply an ACL to a port:
To do...
Enter system view
Enter Ethernet port view
Apply an ACL to the port
You cannot assign an ACL to a member port of a port group.
Configuration example
# Apply ACL 2000 to GigabitEthernet 1/0/1 to filter the inbound packets.
<device> system-view
[device] interface GigabitEthernet 1/0/1
[device-GigabitEthernet1/0/1] packet-filter inbound ip-group 2000

Displaying and Maintaining ACL

Display a configured ACL or all the ACLs
Display a time range or all the time ranges
Display the information about packet filtering
Display information about remaining ACL
resources
Configuring Basic ACL,
Use the command...
system-view
interface interface-type
interface-number
packet-filter inbound acl-rule
To do...
Configuring Advanced
—
—
Required
For description on the acl-rule
argument, refer to ACL Command.
Use the command...
display acl { all | acl-number }
display time-range { all |
time-name }
display packet-filter { global |
interface interface-type
interface-number | port-group
[ group-id ] | unitid unit-id | vlan
[ vlan-id ] }
display acl remaining entry
1-11
ACL, Configuring Layer 2
Remarks
Remarks
Available in
any view.
ACL.