Flow-Based Traffic Accounting; Burst; Traffic Mirroring; Qos Configuration - 3Com WX3000 Series Operation Manual

Table 1-7 Queue-scheduling sequence of SDWRR
Scheduling
algorithm
WRR
SDWRR

Flow-based Traffic Accounting

The function of flow-based traffic accounting is to use ACL rules in traffic classification and perform
traffic accounting on the packets matching the ACL rules. You can get the statistics of the packets you
are interested in through this function.

Burst

The Burst function can provide better packet cache function and traffic forwarding performance. It is
suitable for networks where
Large amount of broadcast/multicast packets and large burst traffic exist.
Packets of high-rate links are forwarded to low-rate links or packets of multiple links with the equal
rates are forwarded to a single link that is of the same rate as that of the incoming links.
Although the burst function helps reduce the packet loss ratio and improve packet processing capability
in the networks mentioned above, it may affect QoS performance. So, use this function with caution.

Traffic mirroring

Traffic mirroring identifies traffic using ACLs and duplicates the matched packets to the destination port.
For information about port mirroring, refer to the Mirroring module of this manual.

QoS Configuration

QoS Configuration Task List

Complete the following tasks to configure QoS:
Configuring Priority Trust Mode
Configuring Priority Mapping
Setting the Priority of Protocol Packets
Marking Packet Priority
Configuring Traffic Policing
Configuring Traffic Shaping
Configuring Traffic Redirecting
Configuring VLAN Mapping
Configuring Queue Scheduling
Collecting/Clearing Traffic Statistics
Queue-scheduling sequence
0, 0, 0, 0, 0, 1, 1, 1, 0, 0, 0, 0, 0, 1, 1, 1
0, 1, 0, 1, 0, 1, 0, 0, 1, 0, 1, 0, 1, 0, 0, 0
Task
1-13
Description
0 indicates packets in
queue0
1 indicates packets in
queue1
Remarks
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional