Configuring The Login Banner; Configuration Procedure - 3Com WX3000 Series Operation Manual

Figure 4-1 Web interface of the access controller engine
3) Set up a Web configuration environment, as shown in
Figure 4-2 Set up a Web configuration environment
4) Log in to the switching engine through IE. Launch IE on the Web-based network management
terminal (your PC) and enter http://192.168.0.101 in the address bar. (Make sure a route is
available between the Web-based network management terminal and the switching engine.)
5) When the login authentication interface (as shown in
the password configured in step 2 and click Login to bring up the main page of the Web-based
network management system.
Figure 4-3 The login page of the Web-based network management system

Configuring the Login Banner

Configuration Procedure

If a login banner is configured with the header command, when a user logs in through Web, the banner
page is displayed before the user login authentication page. The contents of the banner page are the
login banner information configured with the header command. Then, by clicking <Continue> on the
banner page, the user can enter the user login authentication page, and enter the main page of the
Web-based network management system after passing the authentication. If no login banner is
Figure 4-2.
Figure 4-3) appears, enter the user name and
4-3