3Com WX3000 Series Operation Manual page 622

To do...
Configure the probe timeout
time
Configure the type of service
Configure the number of test
packets that will be sent in each
jitter probe
Configure the interval to send
test packets in the jitter test
Start the test
Display test results
6) Configuring SNMP test on HWPing client
Follow these steps to configure SNMP test on HWPing client:
To do...
Enter system view
Enable the HWPing client
function
Create a HWPing test group
and enter its view
Configure the destination IP
address
Configure the source IP
address
Configure the source port
Configure the test type
Configure the number of
probes per test
Use the command...
timeout time
tos value
jitter-packetnum number
jitter-interval interval
test-enable
display hwping results
[ admin-name operation-tag ]
Use the command...
system-view
hwping-agent enable
hwping administrator-name
operation-tag
destination-ip ip-address
source-ip ip-address
source-port port-number
test-type snmpquery
count times
1-11
Remarks
Optional
By default, a probe times out in
three seconds.
Optional
By default, the service type is
zero.
Optional
By default, each jitter probe will
send 10 packets.
Optional
By default, the interval is 20
milliseconds.
Required
Required
You can execute the command
in any view.
Remarks
—
Required
By default, the HWPing client
function is disabled.
Required
By default, no test group is
configured.
Required
By default, no destination
address is configured.
Optional
By default, no source IP
address is configured.
Optional
By default, no source port is
configured.
Required
By default, the test type is
ICMP.
Optional
By default, each test makes
one probe.