Table of Contents
Advertisement
GB4550.book Page 30 Wednesday, June 14, 2000 9:21 PM
English
5.
Enter the Location ID. This is a descriptive title up to 15 characters
long. Refer to the instructions below.
To do this
Enter numbers
Enter spaces
Enter hyphens
Enter alphabetic characters
Enter a unique character
Enter two characters using
the same key
Move the cursor to make
corrections
6.
Press the START key. The display shows NO=<OR LOCATION>.
7.
Enter the alternate fax number. Refer to the instructions following
Step 3.
The display shows G3 COMMUN. SPEED [33.6]. Press NO " key
8.
to adjust the speed and ! YES key to select it.
Note:
If you are experiencing problems communicating with a remote
location , try lowering the FAX SPEED or turning on ECHO
PROTECTION.
The display shows G3 ECHO PROTECTION [OFF]. Press NO "
9.
key to change the setting and ! YES key to select it.
Note:
If the ISDN option is installed, the display will show ISDN DIAL
MODE (G4). Press ! YES key to select G4 as the dial mode for
this One Touch key or press NO " key to change to G3 dial mode
and then press ! YES key to select it.
10. After pressing the ! YES key, the display automatically shows
LOCATION PROGRAMMING ENTER (SRCH, OT, A/D, #)
11. To continue programming One Touch keys, go back to Step 2. If
you are finished programming, press the Select Function key.
12. Lift off the plastic cover above the One Touch label. Using a pencil,
write in the name for your newly programmed One Touch key.
Replace the cover.
30
Use
Numeric keypad (press once).
Space One Touch key
Hyphen key
Locate the character you want on the numeric keypad. Press
that key repeatedly until the character appears.
Press the 0/Unique key repeatedly until the character you
want appears. The following characters are available: ! # & ' (
) * + , - . / : ; = ? · ä ß ñ ö ü Æ Å Ø æ å ø
"
Press the NO
key to move to the next character.
!
"
Press
YES or
NO keys.
Advertisement
Table of Contents
