Table of Contents
Advertisement
GB4550.book Page 9 Wednesday, June 14, 2000 9:21 PM
14. Alarm indicator: This indicator glows red and an alarm sounds
notifies you of any problem that occurs. To turn the alarm indicator
off, press the Stop key and correct the problem.
15. Plus (+) key (One Touch key 8): Each fax number you enter or
program into your fax machine can be up to 32 digits long. When a
number is longer than 32 digits, it is possible to dial this number
using combinations of One Touch keys, Auto Dial numbers or the
numeric keypad. When programming a chain dial number into a
One Touch key or Auto Dial number, press the Plus key at the end
of the first part of the number to indicate to the fax machine that this
is a chain dial number. When programming TSI/CSI and call back
numbers into your fax machine, this key is used to enter a "+"
symbol.
Note:
16. Pause key (One Touch key 10): Use this key on the One Touch
keypad to enter automatic three second pauses in dialling when
programming telephone numbers. For example, you may want to
use this key to tell your fax machine to wait for an outside or
international line to open. Pauses in telephone numbers are marked
by a "P" symbol.
17. Space key (One Touch key 9): Use this key on the One Touch
keypad to enter spaces while programming or to erase previously
programmed information. Unlike the Pause key, spaces are used for
easier reading only and have no effect on dialling.
18. One Touch keypad: For a description of all the functions of the
One Touch keypad, see the following section "One Touch keypad".
19. One Touch labels: After programming a location into a One Touch
key, write the name of the location on the One Touch label. Lift off
the plastic cover and use a pencil to write in the name, then replace
the cover.
20. #/Group key: Once you have programmed some One Touch keys
or Auto Dial numbers, use this key to create groups to allow you to
send the same fax to multiple locations. After you have loaded a
document, press the Auto Dial key and use this key to select the
group you want to send your fax to.
21. 0/Unique key: When dialling, use this key to enter a "0". When
programming your Sender ID or a Location ID, you can use this key
Chapter 1 - Introduction
With the ISDN option installed, chain dial numbers can be
programmed but cannot be used.
English
9
Advertisement
Table of Contents
