Table of Contents
Advertisement
Safety
You should observe the following safety guidelines when working with any
equipment that connects to electrical power or telephone wiring. They can help
you avoid injuring yourself and damaging the WLSE.
The English warnings in this document are followed by a statement number. To
Note
see the translations of a warning into other languages, look up its statement
number in the Regulatory Compliance and Safety Information for the CiscoWorks
1130-19 Wireless LAN Solution Engine.
The following warnings and cautions are provided to help you prevent damage to
the devices or injury to yourself:
Only trained and qualified personnel should be allowed to install, replace, or
Warning
service this equipment. Statement 1030
The safety cover is an integral part of the product. Do not operate the unit
Warning
without the safety cover installed. Operating the unit without the cover in place
will invalidate the safety approvals and pose a risk of fire and electrical
hazards. Statement 117
This equipment must be grounded. Never defeat the ground conductor or
Warning
operate the equipment in the absence of a suitably installed ground conductor.
Contact the appropriate electrical inspection authority or an electrician if you
are uncertain that suitable grounding is available. Statement 1024
Before working on a chassis or working near power supplies, unplug the power
Warning
cord on AC units; disconnect the power at the circuit breaker on DC units.
Statement 12
Before opening the unit, disconnect the telephone-network cables to avoid
Warning
contact with telephone-network voltages. Statement 1041
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
2-2
Chapter 2
Preparing to Install WLSE 1130-19 Hardware
78-16345-01
Advertisement
Table of Contents
