Cisco CiscoWorks Wireless LAN Solution Engine Installation And Configuration Manual page 93

Chapter 5 Setting Up Devices—CiscoWorks 1105/1130/1130-19
To configure the WDS access points using the IOS command line interface:
Log in to an access point that will be a WDS device.
Step 1
Turn on AAA services:
Step 2
aaa new-model
Define the RADIUS servers that you will use for infrastructure authentication
Step 3
and/or client authentication. Consult your RADIUS server documentation for the
correct port numbers. CiscoSecure ACS uses port 1645 for authorization and port
1646 for accounting.
radius-server host [ ip_address | hostname ] auth-port port
acct-port port key shared_secret_key
Define a server group for infrastructure authentication:
Step 4
aaa group server radius server_group_name server radius_server
Define at least one additional server group for wireless client authentication.
Step 5
Configure the AP to run WDS:
Step 6
wlccp wds priority priority interface BVI1
where priority is a value from 1 to 255. Priority determines which AP will be the
active WDS AP when multiple APs are configured to run WDS. The highest
priority is 255.
Configure the Wireless Network Manager (WNM) component:
Step 7
wlccp wnm ip address wlse_ip_address
where wlse_ip_address is the address of the WLSE.
Configure the server group the WDS will use to LEAP authenticate SWAN
Step 8
infrastructure access points. Use the server group name that you created in Step 4.
aaa authentication login named_authentication_list group
server_group_name
wlccp authentication-server infrastructure named_authentication_list
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-16345-01
Setting Up IOS Access Points
5-15