Enter Http Port Settings For Ios Access Points; Enter Wlccp Credentials For Wireless Domain Services (Wds) - Cisco CiscoWorks Wireless LAN Solution Engine Installation And Configuration Manual

Chapter 6 Setting Up Discovery and Device Management—CiscoWorks 1105/1130/1130-19
Step 3

Enter HTTP Port Settings for IOS Access Points

Step 1
Step 2
Step 3

Enter WLCCP Credentials for Wireless Domain Services (WDS)

Step 1
Step 2
Step 3
78-16345-01
Repeat step 2 to add credentials for more devices.
HTTP port settings are required for reports on IOS-based access points; the port
settings are used for the links from reports to access point Web interfaces. The
port you should supply for each device is the port for the access point's Web
interface. To enter HTTP port settings:
Select Devices > Discover > Device Credentials > IOS HTTP Port Settings.
To add a port:
Enter the IP address or range of IP addresses that use this port number.
a.
Enter the port number.
b.
Click Save.
c.
Repeat Step 2 to add more IP addresses and ports.
To configure the WLSE to authenticate with WDS devices:
Select Devices > Discover > Device Credentials > WLCCP Credentials.
Enter the Radius User Name and Radius Password.
This is the user name and password that you set for the WLSE on the AAA server.
Click Save.
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
Adding Device Credentials to the WLSE
6-5