Cisco CiscoWorks Wireless LAN Solution Engine Installation And Configuration Manual page 99

Chapter 5 Setting Up Devices—CiscoWorks 1105/1130/1130-19
Table 5-3 Setting Up Scanning APs Quick Reference
Task
Run inventory on the WLSE.
3.
Enable client registration scanning on the
4.
WLSE.
Configuring a Scanning AP—Using the AP CLI
Configuring a Scanning AP—Using a WLSE Configuration Template
Run Inventory
Enable Client Registration Scanning
78-16345-01
To configure an access point for scanning only, enter the following commands:
config t
int dot11 0 (for interface 0)
station-role scanner
To configure an access point for scanning only from a WLSE configuration
template:
Select Configuration > Templates > IOS > Basic Settings, then select
1.
Scanner Access Point.
Select Configuration > Templates > IOS > Network Interfaces. Select a
2.
radio and select Scanner Access Point.
Select Administration > Devices > Discover > Inventory and run inventory so
the WLSE can update the role of the AP. The scanning APs will be listed in the
WLSE's Scanning AP system group.
For more information, see the online help or the "Managing Devices" chapter of
the User Guide for the CiscoWorks Wireless LAN Solution Engine, Release 2.7.
Select Radio Management > Radio Monitoring and enable Client Registration
Scanning to detect bug-lighted clients.
For more information, see the online help or the "Radio Management" chapter of
the User Guide for the CiscoWorks Wireless LAN Solution Engine, Release 2.7.
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
References
Run Inventory, page 5-21
Enable Client Registration Scanning, page 5-21
Setting Up IOS Access Points
5-21