Table of Contents
Advertisement
Chapter 6
Setting Up Discovery and Device Management—CiscoWorks 1105/1130/1130-19
Add community strings for all of the devices to be discovered if you have not
Step 4
already done so. For details on adding community strings, see
Community Strings for All Managed Devices, page
strings, click Next.
Add one or more initiating IP addresses (seeds) to be used for this one-time
Step 5
discovery only:
Note
a.
b.
c.
If the discovery summary is correct, click Finish to run the discovery. The
Step 6
discovery will begin within 2 minutes.
If the summary is not correct, click Back to make changes in any of your settings.
A popup message displays the name of the discovery and the Discovery Run
Step 7
Details window appears. Click Refresh to update the Job Run Log.
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-16345-01
If CDP is not enabled, you still can discover devices by entering each of
their IP addresses as seeds, however the connectivity between switches
and access points will not be discovered.
Enter the IP addresses or device names in the Add Seed Values text box and
click >>.
Set the CDP distance. If the distance is set to 1, only the immediate neighbors
of the seed devices are discovered. Set the distance appropriately to discover
the entire wireless network. Set the distance to 1 if you are adding all devices
as seeds.
Routers and switches that do not have access points attached to them
Note
are used when computing CDP distance. However, such devices will
not appear in the discovered devices list.
Click Next.
Discovering Devices
Enter SNMP
6-2. After adding community
6-9
Advertisement
Table of Contents
