Radio Management Setup-Ios Devices - Cisco CiscoWorks Wireless LAN Solution Engine Installation And Configuration Manual

Setting Up IOS Access Points
Radio Management Setup—IOS Devices
Note
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
5-10
Make sure you also configure all access points for basic network management.
See Basic Network Management Setup—IOS Devices, page
Setting up access points for radio management involves configuring all access
points to register with Wireless Domain Services (WDS). WDS provides wireless
client roaming and radio management aggregation.
Only Cisco Aironet 1100 and 1200 series access points support WDS. For
information about the supported access points and IOS firmware versions, see the
WLSE 2.7 Supported Devices Table on cisco.com.
This section contains the following information:
About WDS Devices, page 5-11
•
About Configuring Authentication, page 5-11
•
Radio Management Setup Quick Reference, page 5-12
•
Using Access Points as WDS Devices, page 5-12
•
Using a Wireless LAN Services Module (WSM) as the WDS Device,
•
page 5-18
Configuring Infrastructure Access Points to Register with WDS Access
•
Points, page 5-18
Configuring Infrastructure Access Points to Register with a Wireless LAN
•
Services Module (WSM), page 5-20
Configuring Scanning APs, page 5-20
•
Configuring the WLSE, page 5-22
•
Confirming the Configuration, page 5-22
•
Chapter 5 Setting Up Devices—CiscoWorks 1105/1130/1130-19
5-4.
78-16345-01