Table of Contents
Advertisement
Adding Device Credentials to the WLSE
Adding Device Credentials to the WLSE
Enter SNMP Community Strings for All Managed Devices
Note
Step 1
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
6-2
Chapter 6
Setting Up Discovery and Device Management—CiscoWorks 1105/1130/1130-19
This section provides procedures for entering the following required device
credentials on the WLSE:
For all managed devices, you must enter SNMP credentials.
•
For access points, the following additional credentials are required:
•
For IOS-based access points, you must enter Telnet or SSH credentials
–
and IOS HTTP port settings.
For non-IOS access points, you must enter HTTP credentials.
–
For radio management, you must enter WLCCP credentials.
•
SNMP community strings are used for discovery and for enabling WLSE features,
such as AP configuration jobs and radio management. The community string must
be set on each device, as described in
Devices—CiscoWorks
strings on the WLSE as necessary.
If you are importing devices, you do not need to enter their community
strings.The community strings will be imported along with the devices and will
be listed in WLSE Communities screen, in which you can modify and delete
strings as required. For more information, see
To configure community strings on the WLSE:
Select Devices > Discover > Device Credentials > SNMP Communities.
This screen contains a default entry which can cover all devices, provided
Note
device community strings are set to the default (public).
Chapter 5, "Setting Up
1105/1130/1130-19.". You can enter as many community
Import Devices, page
6-11.
78-16345-01
Advertisement
Table of Contents
