Chapter 5 Setting Up Devices-Ciscoworks 1105/1130/1130-19; Setting Up Non-Ios Access Points And Bridges - Cisco CiscoWorks Wireless LAN Solution Engine Installation And Configuration Manual

Setting Up Non-IOS Access Points and Bridges

78-16345-01
Setting Up Devices—CiscoWorks
1105/1130/1130-19
You must set up devices before the WLSE can discover and manage them and
before you can use WLSE features such as monitoring, reporting, configuration,
firmware upgrade, and radio management. This section describes initial setup
tasks for the following devices:
Non-IOS access points and bridges—See
•
and Bridges, page 5-1
IOS access points and bridges—See
•
Routers and switches—See
•
AAA servers—Setting Up AAA Servers, page 5-25
•
This section provides setup procedures to prepare non-IOS access points for basic
network management by the WLSE. You can perform initial setup in two ways:
Open a web browser session on each access point—See
•
Web Interface, page
Use the WLSE startup configuration option for first-time device
•
configuration and apply a configuration template to a number of access
points—See Set Up Using a WLSE Configuration Template, page
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
C H A P T E R
Setting Up Non-IOS Access Points
Setting Up IOS Access Points, page 5-4
Setting Up Routers and Switches, page 5-24
5-2.
5
Set Up Using the
5-4.
5-1