Setting Up Routers And Switches - Cisco CiscoWorks Wireless LAN Solution Engine Installation And Configuration Manual

Setting Up Routers and Switches

Setting Up Routers and Switches
Note
Table 5-4 Setup Procedures for Routers and Switches
Task
1. Enable CDP and
verify that access
points and bridges
are visible from the
router or switch.
2. Enable SNMP
and set up
community strings.
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
5-24
Only routers and switches that have properly configured access points or bridges
attached to them will be discovered.
Configure each router and switch as shown in
Procedure
In enable mode, verify that CDP is running on the
1.
device by using one of the following commands:
On IOS-based devices—show cdp run.
•
On Hybrid OS-based Catalyst
•
switches—show cdp.
If CDP is not running, in global configuration mode,
2.
enter cdp run to enable CDP.
To verify that access points or bridges are visible in
3.
the device's CDP table, enter show cdp neighbors.
On IOS-based devices, enter configuration mode and use
the snmp community community_string ro command.
On Hybrid OS-based Catalyst devices, enter enable
mode and use the set snmp community read-only
community_string command.
Chapter 5 Setting Up Devices—CiscoWorks 1105/1130/1130-19
Table 5-4 on page 5-24.
Notes
CDP is required for
the WLSE to discover
the device.
SNMP is required for
the WLSE to discover
and manage the
device.
78-16345-01