Table of Contents
Advertisement
Setting Up IOS Access Points
Configuring the WLSE
Confirming the Configuration
Note
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
5-22
The WLSE is the Wireless Network Manager (WNM) component of SWAN.
The WLSE polls and aggregates radio management data from WDS devices and
processes this data. The following configuration is required on the WLSE for
radio management:
SWAN components communicate via a Cisco proprietary technology called
•
WLCCP. You must enter the WLCCP username and password in the WLSE.
This username and password is used to LEAP authenticate the WLSE to the
WDS APs in the network. See
Domain Services (WDS), page
Enter the SNMP read-only and read/write communities for all managed IOS
•
access points. See
Devices, page
6-2.
•
Enter Telnet/SSH credentials for IOS access points. See
Credentials for IOS Access Points, page
After you complete all the configuration procedures, you should confirm that the
configuration is correct and that the SWAN components are communicating
properly. Perform the following confirmation steps on the active WDS APs.
There are two ways to confirm configuration:
Using the Web interface—See
•
Configuration, page
Using the command-line interface—See
•
to Validate the Configuration, page
To determine which WDS APs are actively providing WDS services, you can use
the WDS Summary Report on the WLSE. For more information, see the online
help or the "Reports" chapter in the User Guide for the CiscoWorks Wireless LAN
Solution Engine, Release 2.7.
Chapter 5
Setting Up Devices—CiscoWorks 1105/1130/1130-19
Enter WLCCP Credentials for Wireless
6-5.
Enter SNMP Community Strings for All Managed
Using the Web-based Interface to Validate the
5-23.
5-23.
Enter Telnet or SSH
6-4.
Using the Command-Line Interface
78-16345-01
Advertisement
Table of Contents
