Table of Contents
Advertisement
Chapter 4
Basic Setup—CiscoWorks 1105/1130/1130-19
Step 2
Step 3
Step 4
Table 4-2
General Configuration
Prompt
host name:
domain name:
<username> password:
confirm password:
eth0 IP address:
eth0 network mask:
default gateway IP
address:
78-16345-01
If you are using a Windows terminal emulator as a console, it is
Note
recommended that you use the Windows Hyper Terminal application.
Power on the WLSE.
When the system finishes booting, a login prompt appears on the console.
At the login prompt, enter setup.
When you boot the system for the first time, it is not configured. Logging in as
setup allows you to configure the system.
Enter responses to the first set of prompts to configure the WLSE's connectivity.
Table 4-2
describes how to respond to the prompts. After each response, press
Enter to proceed to the next prompt.
Response Description
System host name.
System domain name.
Sets the password for the default user admin. Characters
you type do not appear on screen.
Default user admin is reserved and cannot be
Note
deleted or changed.
You can use the admin password to log into the Web
interface and and to connect via Telnet/SSH.
Password length is unlimited, and you can use the
alphanumeric characters (A-Z, a-z, 0-9) plus the
underscore(_). Passwords are case sensitive.
IP address of Ethernet 0 interface.
Network mask of Ethernet 0 interface.
IP address of default router.
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
Configuring the WLSE's Network Information
Sample Response
SolutionEngine
cisco.com
wq1Cvu2pl
209.165.200.224
255.255.255.224
209.165.200.224
4-3
Advertisement
Table of Contents
