Cisco CiscoWorks Wireless LAN Solution Engine Installation And Configuration Manual page 128

Upgrade Methods
Quick Reference
Task
Back up WLSE.
1.
Download image to an FTP server.
2.
Create repository.
3.
Install upgrade.
4.
Create the Repository
Create a Local Repository
Step 1
Step 2
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
A-8
The basic tasks in installing software upgrades by using the CLI are listed in
below. See the referenced sections for details about these tasks.
Reference
Backing Up the WLSE, page A-2
Downloading the Upgrade Image, page A-2
Create the Repository, page A-8
Install the Software, page A-10
Upgrades are normally installed from a repository, which can be located on the
WLSE to be upgraded or on a remote Windows FTP server. This section contains
the following topics:
Create a Local Repository, page A-8
•
Create a Repository on a Windows Server, page A-9
•
Use this procedure to create a repository on the WLSE to be upgraded.
Procedure
Log in using Telnet or SSH to the WLSE to be upgraded.
Specify the FTP site that will be the source of the software updates by using the
following command:
repository source ftp:// source/path
where source is the hostname or IP address of the FTP server on which the image
resides and path is the path to the image files.
If the message "unable to obtain file" appears, you have entered the wrong
password.
Appendix A Installing Software—CiscoWorks 1105/1130/1130-19
78-16345-01