Cisco CiscoWorks Wireless LAN Solution Engine Installation And Configuration Manual page 84

Setting Up IOS Access Points
To configure SNMP, enter the following commands in the sequence shown. The
Step 4
first command includes the ISO view. The read-only community string, is
required for discovery and the fault and report features on the WLSE. The
read/write community string is required for AP firmware management, AP
configuration, and all radio-management functions (client walkabout, radio
scanning, and so on).
a.
a.
b.
Note
IOS access points that do not have an ISO view will be placed in the
Caution
Misconfigured Devices system group after discovery and a fault will be generated.
The fault refers to a "dot 11 MIB" problem.
(Optional) It is useful to set the system name, contact, and location SNMP
Step 5
variables to make the device more manageable. Use the following commands:
configuration terminal
hostname access_point
snmp-server location AP_location
snmp-server contact AP_contact
where access_point is the system name, AP_location is its location, and
AP_contact is the name of the contact person.
You can use either Telnet or SSH to push configuration templates to IOS access
Step 6
points. To use templates to configure IOS access points, you must configure either
Telnet or SSH or both, as follows.
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
5-6
Include the ISO view:
snmp-server view iso iso included
Configure the read-only community:
snmp-server community ro_ommunity_string view iso ro
Configure the read/write community:
snmp-server community rw_community_string view iso rw
The community strings must also be entered on the WLSE. See
SNMP Community Strings for All Managed Devices, page
Chapter 5 Setting Up Devices—CiscoWorks 1105/1130/1130-19
Enter
6-2.
78-16345-01