Table of Contents
Advertisement
Chapter 5
Setting Up Devices—CiscoWorks 1105/1130/1130-19
In the Global Properties section:
a.
b.
c.
Configure a server group for authenticating the SWAN infrastructure
Step 5
components.
In the Server Groups section:
a.
b.
c.
The WDS access point must also register and authenticate itself to the WDS to
Step 6
participate in the SWAN hierarchy, so the WDS AP is also an infrastructure AP.
To authenticate and register the WDS AP as an infrastructure AP:
a.
b.
c.
(Optional) Select Preview to see a preview of the configuration template.
Step 7
Select Save, then click the Save button.
Step 8
Select Yes to apply the template immediately or select No to save the template.
Step 9
For information on configuration jobs, see the "Managing Device Configuration"
chapter in the User Guide for the CiscoWorks Wireless LAN Solution Engine,
Release 2.7.
To configure authentication for wireless clients, see the relevant AP
Note
documentation.
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-16345-01
Select Enable.
Enter the Wireless Domain Services priority. This value determines which
access point will serve as the active WDS when multiple access points are
configured to run WDS on the same subnet. Valid priority values are 1-255,
with 255 being the highest.
Enter the WLSE's IP address in the WNM IP Address field.
Enter one or more server names or server IP addresses.
Under Use Group For, select Infrastructure Authentication.
Click Save.
Select Wireless Services > AP Configuration.
Select Enabled as the Wireless Services option.
Enter a username and password that can be LEAP authenticated by the AAA
servers in the infrastructure server group.
Setting Up IOS Access Points
5-17
Advertisement
Table of Contents
