Cisco CiscoWorks Wireless LAN Solution Engine Installation And Configuration Manual page 133

Appendix A Installing Software—CiscoWorks 1105/1130/1130-19
To reimage your WLSE, perform the following steps:
Connect a console to the WLSE's serial/console port:
Step 1
•
•
Log in as the admin user, and enter the password created when the WLSE was
Step 2
configured.
Put the Recovery CD in the WLSE's CD drive (on the front panel).
Step 3
Enter the following command. The WLSE will reboot.
Step 4
reload
At the following prompt, enter
Step 5
Do you wish to continue (Yes/[No]/Rescue) yes
If you do not want to re-image the WLSE, enter rescue. For more information
Caution
about the rescue image, see the User Guide for the CiscoWorks Wireless LAN
Solution Engine, Release 2.7.
When the WLSE ejects the Recovery CD, remove it.
Step 6
At the following prompt, enter yes:
Step 7
Do you wish to reload and start the install?(yes/[no]) yes
Result: The WLSE is re-imaged and reboots.
When the Recovery CD ejects from the CD drive, remove it.
Step 8
When the installation completes, the login prompt appears on the console.
Restore the backup.
Step 9
For information about restoring backups, see the User Guide for the CiscoWorks
Wireless LAN Solution Engine, Release 2.7 or the online help.
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-16345-01
For the WLSE 1105, use the serial port on the front panel; do not use the serial
port on the back panel for a console.
For the WLSE 1130 or WLSE 1130-19, use the serial port on the back panel.
to start the Recovery CD:
yes
Upgrade Methods
A-13