Table of Contents
Advertisement
Core Logic Module - SMI Status and ACPI Registers - Function 1
Table 6-34. F1BAR1+I/O Offset: ACPI Support Registers (Continued)
Bit
Description
Offset 12h-13h
In order for the ACPI events described below to generate an SCI, the SCI_EN bit must also be set (F1BAR1+I/O Offset 0Ch[0] = 1).
The SCIs enabled in this register are globally enabled by setting F1BAR1+I/O Offset 0Ch[0] to 1. The status of the SCIs is reported in
F1BAR1+I/O Offset 10h.
15:12
Reserved.
11
Reserved.
10
GPWIO2_EN. Allow GPWIO2 to generate an SCI.
0: Disable.
1: Enable.
A fixed high-to-low or low-to-high transition (debounce period) of 31 µs exists in order for GPWIO2 to be recognized.
The setting of this bit can be overridden via F1BAR1+I/O Offset 15h[6] to force an SMI.
9
GPWIO1_EN. Allow GPWIO1 to generate an SCI.
0: Disable.
1: Enable.
See F1BAR1+I/O Offset 07h[3] for debounce information.
The setting of this bit can be overridden via F1BAR1+I/O Offset 15h[5] to force an SMI.
8
GPWIO0_EN. Allow GPWIO0 to generate an SCI.
0: Disable.
1: Enable.
See F1BAR1+I/O Offset 07h[3] for debounce information.
The setting of this bit can be overridden via F1BAR1+I/O Offset 15h[4] to force an SMI.
7
Reserved. Must be set to 0
6
USB_EN. Allow USB events to generate a SCI.
0: Disable.
1: Enable
5
THRM_EN. Allow THRM# to generate an SCI.
0: Disable.
1: Enable
4
SMI_EN. Allow SMI events to generate an SCI.
0: Disable.
1: Enable
3
GPIO_EN. Allow GPIOs (GPIO47-GPIO32 and GPIO15-GPIO0) to generate an SCI.
0: Disable.
1: Enable.
F0BAR0+I/O Offset 08h/18h selects which GPIOs are enabled for PME generation. This bit (GPIO_EN) globally enables
those selected GPIOs for generation of an SCI.
2:1
Reserved. Must be set to 0.
0
PWR_U_REQ_EN. Allow power-up request events from the SuperI/O module to generate an SCI.
0: Disable.
1: Enable.
A power-up request event is defined as any of the following events/activities: Modem, Telephone, Keyboard, Mouse, CEIR
(Consumer Electronic Infrared)
AMD Geode™ SC3200 Processor Data Book
GPE0_EN — General Purpose Event 0 Enable Register (R/W)
32581C
Reset Value: 0000h
251
Advertisement
Table of Contents
