2
INSTALLATION AND CONNECTIONS
■ Power supply connections
Use the DC power supply with a 22 A capacity when
operating the transceiver with AC power. Refer to the
diagrams below.
■ Connecting a DC power supply
CONNECTING THE PS-126 DC POWER SUPPLY
AC outlet
AC cable
CONNECTING A NON-ICOM DC POWER SUPPLY
AC outlet
A DC power supply
13.8 V; at least 22 A
Red
+
AC cable
19
PS-126
DC power cable
Transceiver
DC power
socket
Supplied DC
Black
power cable
_
30 A fuses
CAUTION:
Before connecting the DC power
cable, check the following important items. Make
sure:
• The [POWER] switch is OFF.
• Output voltage of the power source is 12–15 V
when you use a non-Icom power supply.
• DC power cable polarity is correct.
Red
: positive + terminal
: negative _ terminal
Black
Transceiver
NOTE: When using the PS-126,
the IC-7000 Europe version com-
plies with EMC directives even if
the OPC-1457R is not used.
For European versions
DC power
OPC-1457R
Connect to
power supply
Transceiver
[GND]
socket