D Programming In Vfo Mode - Icom IC-7000 Instruction Manual

8
MEMORY OPERATION
■ Memory programming
Memory channel programming can be performed
either in VFO mode or in memory mode.

D Programming in VFO mode

q Push [PBT/M-ch/RIT] momentarily to select the
M-ch/RIT function, if the twin PBT is selected.
• [PBT/M-ch/RIT] indicator (Green) goes out.
w Set the desired frequency and operating mode in
VFO mode.
• If you want to program the split frequency function,
program both receive and transmit frequencies into
VFO A and B, then turn ON the split function. (p. 89)
• If you want to program a repeater function, set a tone
frequency (p. 60) in addition to the receive/transmit
frequencies.
e Select M-2.
r Push [F-1 MEM] to display the memory channel
contents.
• Memory channel contents appear above the multi-
function key indicator.
• Push [F-1 LST] to display the memory channel list.
This is convenient for selecting the desired channel.
Push [Z(
menu / grp
t Rotate [M-ch] to select the desired memory
channel.
• " " and "---,---,--" appear if the selected memory
channel is a blank channel (and does not have
contents).
• Rotating [RIT] (outer) control changes the bank.
y Hold down [F-2 MW] for 1 second to program the
displayed frequency and operating mode into the
selected memory channel.
To check the programmed contents, push [F-4 V/M]
to select memory mode.
101
)] to exit the memory channel list.
Menu group selection
Hold down [MENU/GRP] for 1 second.
Selection from: M, S or G(Graphic)
Menu selection (Example: M)
Push [MENU/GRP] momentarily.
Selection from: M-1, M-2 or M-3
[PBT/M-ch/RIT] switch/[M-ch] (inner) control
[PBT/M-ch/RIT] indicator
[MENU/GRP]
[RIT] (outer) control
[EXAMPLE]: Programming 7.088 MHz/LSB into ch 12.
Either Either
Y Y or Z Z
or
[F-2]
MW
Push for
1 sec.