Scan Operation; Scan Types; Preparation - Icom IC-7000 Instruction Manual

9

SCAN OPERATION

■ Scan types

PROGRAMMED SCAN
Repeatedly scans between two scan edge frequencies
(scan edge memory channels 1A and 1B).
Scan edge 1A or 1B
This scan operates in VFO mode.
MEMORY SCAN
Repeatedly scans all programmed memory channels.
Mch 2
Mch 1
ß (select)
Mch 99
ß (select)
This scan operates in memory mode.

■ Preparation

❍ Channels
For programmed scan: Program scan edge frequencies
into scan edge memory channels 1A and 1B. (p. 101)
For memory scan: Program two or more memory
channels except scan edge memory channels.
For memory select scan: Designate two or more
memory channels as select memory channels—
select a memory channel, then push [F-2 SEL] in the
S-2 menu (memory mode) to designate the channel
as a select memory channel.
For priority watch: Program one memory channel to
be watched.
❍ Scan resume ON/OFF
You can select the scan to resume or cancel when
detecting a signal, in the miscellaneous (others) Set
mode, item "SCAN Resume." Scan resume ON/
OFF must be set before operating a scan. See page
132 for ON/OFF setting and scan resume condition
details.
❍ Scan speed
Scan speed can be selected from 2 levels, high or low,
in the miscellaneous (others) Set mode. See page
132 for details.
111
Scan
Scan edge 1B or 1A
Jump
BLANK
ß (select)
Mch 3 Mch 4
Mch 5
ß (select)
Mch 7 Mch 6
ß (select)
PRIORITY WATCH
Checks for signals on a memory while operating on a
VFO frequency.
VFO
frequency
This scan operates in VFO mode.
SELECTED MEMORY SCAN
Repeatedly scans all selected memory channels.
ß (select)
Mch 2 Mch 3
Mch 1
ß (select)
Mch 99 Mch 7
ß (select) ß (select)
This scan operates in memory mode.
❍ Squelch status
● Scan starts with the squelch open
For programmed scan:
When the tuning step is 1 kHz or less:
The scan continues until it is stopped manually— it
does not pause* even if signals are detected.
* The scan is paused when the squelch is closed
and then opened (scan resumes after 10 sec. has
passed when the scan resume is ON; the scan is
cancelled when the scan resume is OFF).
When the tuning step is more than 5 kHz:
The scan pauses on each step when the scan
resume is ON; not applicable when the scan resume
is OFF.
For memory scan:
Scan pauses on each channel when the scan resume
is ON; not applicable when the scan resume is OFF.
● Scan starts with squelch closed
Scan stops when a signal is detected.
• If the scan resume is set to ON in the scan Set mode,
the scan pauses for 10 sec. when detecting a signal,
then resumes. When a signal disappears while scan
is paused, scan resumes 2 sec. later.
Memory
channel
BLANK
Mch 4
Mch 5
ß (select)
Mch 6