Operating Cw - Icom IC-7000 Instruction Manual

4
RECEIVE AND TRANSMIT

■ Operating CW

q Connect a paddle or straight key as on page 22.
w Push [Y( )]/[Z(
band
band or push a band key on the HM-151.
e Push [MODE] momentarily to select CW mode.
• After CW mode is selected, hold down [MODE] for 1
second to toggle between CW and CW-R modes.
r Rotate [DIAL] to tune in a desired signal with the
desired tone frequency.
t Rotate [AF] to set audio to a comfortable listening
level.
y Set CW break-in operation as semi break-in, full
break-in or OFF.
• Hold down [MENU/GRP] for 1 second once or twice
to select the menu group M.
• Push [MENU/GRP] momentarily one or more times
to select the menu M-3.
• Push [F-1 BRK] one or more times to select the CW
break-in operation.
• " ," " ," and "OFF (no indication)" appears.
➧ BK-IN : semi break-in
➧ F-BK : full break-in
➧ OFF : no break-in (ACC socket connection is
necessary as shown on page 22.)
u Set the CW delay time when semi break-in
operation is selected.
• Hold down [F-1 BRK] for 1 second to enter the
break-in delay time Set mode.
• Rotate [DIAL] to set the desired delay time.
i Set CW setting in the keyer Set mode (S-1).
• Hold down [MENU/GRP] for 1 second once or twice
to select the menu group S.
• Push [MENU/GRP] momentarily one or more times
to select the menu S-1.
• Push [F-2 KEY], [Z(
enter the keyer Set mode. (p. 49)
o Key to transmit, use the electronic keyer or
straight key to send your CW signals.
• [TX] indicator lights red.
• The Po meter indicates transmitted CW signal
strength.
!0 Stop keying to return to receive.
41
)] to select the desired
band
)], then [F-4 SET] to
menu / grp
[AF] [MODE] [TX] indicator
[MENU/GRP] [F-1] [F-2] [F-4]
"CW" or "CW-R" appears
Appears
LSB USB CW RTTY AM WFM
R
VFO A
S1 3 5 7 9 20 40 60dB
P 5 10
O
M4 1/4 KEY AGC
F 2
Semi break-in operation is selected.
Delay time of 7.5 dots is selected
for semi break-in operation.
[Y]
[Z]
[DIAL]
CH