Hm-151 [F-1]; Hm-151 [F-2]; Mic Up/Down Speed; Quick Rit/∂Tx Clear - Icom IC-7000 Instruction Manual

13
SET MODE
■ Miscellaneous (others) Set mode

30 HM-151 [F-1]

This item programs one of several functions to [F-1]
key of HM-151. Programmable key assignments are
described as below.
"P.AMP/ATT" (Preamplifier/attenuator),
"NB" (Noise blanker),
"NR" (Noise reduction),
"MNF" (Manual notch filter),
"ANF" (Auto notch filter),
"TS" (Tuning step),
"SPL" (Split operation),
"A/B" (VCO A/B selection),
"MCL" (Memory clear),
"BNK" (Bank selection),
"COM" (Speech compressor),

31 HM-151 [F-2]

This item programs one of several functions to [F-2]
key of HM-151. Programmable key assignments are
same as above.

32 MIC Up/Down Speed

This item sets the rate at which frequencies are
scanned when the microphone (HM-151) [Y]/[Z]
keys are held down. High or low can be selected.
33 Quick RIT/∂TX Clear
This item selects the RIT/∂TX frequency clearing in-
struction for the [F-3 CLR] key.
See pages 73, 86 for details.

34 SSB/CW Synchronous Tuning

This item selects the displayed frequency shift func-
tion from ON or OFF.
When this function is activated, the received signal
will remain the same even when the operating mode
is changed between SSB and CW.
The frequency shifting value may differ according
to the CW pitch setting.
133
(continued)
MPW
Memo pad wr ite is pro -
grammed. (default)
"AGC" (AGC selection),
"TBW" (TX filter width),
"DUP" (Duplexer),
"TON" (FM tone operation),
"MET" (Meter selection),
"VSC" (Voice squelch control),
"MPW" (Memo pad write),
"MPR" (Memo pad read),
"<SCOPE>" (Scope selection),
"<METER>" (Multi-meter selection)
MPR
M e m o p a d r e a d i s p r o -
grammed. (default)
HIGH
High speed (default,
5 tuning steps/second)
ON
Clears the RIT/∂TX fre-
quency when [F-3 CLR] is
pushed momentarily.
ON
The displayed frequency
shifts when the operating
mode is changed between
SSB and CW.
ANF
Auto notch filter is pro-
grammed.
NB
Noise blanker function is
programmed.
LOW
Low speed
(2.5 tuning steps/second)
OFF
Clears the RIT/∂TX fre-
quency when [F-3 CLR] is
held down for 1 second. (de-
fault)
OFF
The displayed frequency
does not shift.
(default)