Table of Contents
Advertisement
6
SPEAKER-MICROPHONE
I Optional HM-168 description
Alligator type clip
To attach the speaker-mic.
to your shirt or collar, etc.
PTT switch
Transmits while pushed
Receives while released
Microphone
Speaker
Turn the transceiver power OFF
when connecting the HM-168.
NEVER immerse the connector in water. If the connector becomes
wet, be sure to dry it BEFORE attaching it to the transceiver.
NOTE: The microphone is located at the top of the speaker-mi-
crophone, as shown in the diagram above. To maximize the
readability of your transmitted signal (voice), hold the micro-
phone approx. 5 to 10 cm (2 to 4 inches) from your mouth, and
speak in a normal voice level.
34
I Attachment
Attach the connector of the speaker-microphone into the [SP MIC]
jack on the transceiver and tighten the screw.
IMPORTANT: KEEP the [SP MIC] jack cover attached to the
transceiver when the speaker-microphone is not in use. (p. 3)
Water will not get into the transceiver even if the cover is not at-
tached, however, the terminals (pins) will become rusty, or the
transceiver will function abnormally if the connector becomes
wet.
6
SPEAKER-MICROPHONE
CAUTION: Attach the
[SP MIC] jack securely to
prevent accidental drop-
ping, or water intrusion in
the jack.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
35
Advertisement
Table of Contents
