Section 3 Scan Operation; Scan Type; D Vfo Scan; D Memory Scan - Icom IC-T10 Advanced Manual

3
SCAN OPERATION

Scan Type

Scanning is a versatile function that can automatically search for signals. A scan makes it easier to locate stations
to contact or listen to, or to skip unwanted channels or frequencies.

D VFO scan

Scans for signals within the specified frequency range.
Full scan (ALL):
Repeatedly scans the entire VHF and UHF bands.
RX frequency
lower end
Scan
P SKIP
Jump
Band scan (BAND):
Repeatedly scans the selected band.
Program scan (1 ~ 3):
Repeatedly scans the set Program Scan range.
L A Program Scan range must be set to start a Program
scan.
Lower edge
Scan range
PSKIP Scan
Jump
Jump
RX frequency
upper end
P SKIP
Upper edge
PSKIP

D Memory scan

The Memory scan searches signals on the
preregistered memory channels.
ALL scan (ALL):
Repeatedly scans all memory channels.
Selected band scan (BAND):
Scans all memory channels on the same frequency
band as the selected channel.
Tone scan
The Tone scan searches for signals with tone
frequencies or DTCS codes from stations using the
Tone Squelch function. (p. 6-7)
L A Tone scan is usable in the VFO, Memory, or Call
channel modes.
L During a scan, rotate [DIAL] to change the scan
direction.
L See pages 6-5 and 6-6 about the Tone Squelch and
DTCS Code Squelch functions.
3-2