Programming Memory Channels; D Programming In The Vfo Mode; D Programming In The Memory Mode - Icom IC-7200 Instruction Manual

■

Programming Memory channels

You can program the Memory channels in either the
VFO mode or the Memory mode.
D
Programming in the VFO mode
q V/M
Push to select the VFO mode.
w
Rotate [DIAL] to set the desired frequency, and
then push to set the operating mode.
MODE
e
Rotate [M-CH] to select the desired memory chan-
nel.
• If the RIT control indicator lights orange, push
• "
" appears if the selected memory channel is a
blank channel (one without any stored data).
Lower channels
r Hold down
for 1 second to enter the displayed
MW
frequency and operating mode into the selected
memory channel.
• Three beeps sound when memory entry is completed.
D
Programming in the Memory mode
q V/M
Push to select the Memory mode.
w
Rotate [M-CH] to select the desired memory chan-
nel.
• If the RIT control indicator lights orange, push
• Memory channel contents appear in the display.
Lower channels
e
Rotate [DIAL] to set the desired frequency, and
push to set the operating mode.
MODE
• To program a blank channel, directly enter the frequen-
cy entry with the keypad. (p. 16)
r Hold down
for 1 second to enter the displayed
MW
frequency and operating mode into the memory
channel.
• Three beeps sound when memory entry is completed
M-CH/RIT
.
SET
RIT control indicator
goes out
Higher channels
M-CH/RIT
.
SET
RIT control indicator
goes out
Higher channels
MEMORY OPERATION
[EXAMPLE]: Programming 7.088 MHz/LSB
into channel 12.
VFO mode
7.088 MHz/LSB are programmed into channel 12.
[EXAMPLE]: Programming 21.280 MHz/USB
into channel 18.
Memory mode
Current frequency and mode in channel 18
New frequency and mode entered
Write new data into channel 18
21.280 MHz/USB
are now in channel 18.
4
Push
Rotate [DIAL]
1
Push
2
3
Rotate [M-CH]
4
5
Hold down
6
7
8
9
10
11
Push
12
13
Rotate [M-CH]
14
15
16
Rotate [DIAL]
Push
17
18
Hold down
19
20
21
22