Operation - ProScan PS20112 Owner's Manual

First-Time Operation
The steps below will help you get your TV connected and
working quickly. The page numbers on which you can find
detailed instructions for each of these steps are also listed
for your convenience.
1 UnpackTVand accessories.
The accessories that came packed with your TV include a
remote control, four AAA batteries, power cord, and
antenna adapter.
Iili
Connectantenna or cable-TV system.
Most antenna or cable-TV systems can be connected as
shown here.
Back of "IV CABLE/AHTENNA
ANTA
Incoming Cable ANT B
from Antenna or
Cabls-W System @
@
CONVERTER
• Details for connecting a home antenna to your TV are on
page 32.
• Details for connecting a cable-TV system to your TV are
on page 33-34.
• Details for connecting a VCR to your TV are on
pages 37-40.
Attach power cord.
First attach the flat end of the power cord completely into
the connector on the back of your TV, and then plug the
other end into a wall outlet.
Be sure to insert the plug completely.
DoThis
Not This
4 Install batteries in remote control.
Details are on page 5.
L_
Number Buttons--
--VOLUME Buttons
5 Turn on TV, adjustthe volume, and select a channel.
To turn on the TV, press the TVbutton on the master
remote or press the POWER button on the simple remote.
When using the remote, remember to point it at the
front of the TV.
2 Press the VOLUME up or down button to adjust the
volume to a desired level.
Press the CHANNEL up or down button to select the next
channel in memory. You can also press two number
buttons to select a channel. Channels 2-13 and 91 were
programmed into the channel memory at the factory, so
pressing CHANNEL up or down stops at these channels
only. When you start the autoprogramming feature
(described next), your set will automatically scan
through all channels and place the active channels for
your area into its channel memory.
6 AutoProgramthe TV's channel memory.
To start the TV autoprogramming
itself, press the MENU
button repeatedly to select the SETUP
MENU
and then
press the + button to display the setup functions. Press
MENUagain to select the AUTOPROGRAM function, then
press +. Details are on page 18.
Af, J dlo.Men_.
Patelhtal,.Ctrl;:Off
Ik'_m_vam. I I Ctian:Ctrl:Normalv
You can also add and delete channels from memory as
desired. Press MENU repeatedly to select the SETUP
MENU, t hen press + to display the setup functions. Press
MENU repeatedly to select the CHAN MEM function, then
select the desired channel number and press + to add or
- to erase the channel. Details are on page 19.