Operation - ProScan PS27123 Owner's Manual

First-Time Operation
The steps below will help you get your TV connected and
worldng quickly. The page numbers on which you can find
detaiiled instructions for each of these steps are also listed
for your convenience.
1 UnpackTV and accessories.
The accessories that came packed with your TV include
two remote controls, six AAA batteries, power cord, and
antenna adapter.
Important Information: Optional Stand ..
A matching stand has been designed to be used with this
TV receiver. The recommended stand, Model RB2710, is
provid_ d with hardware to secure the TV to the stand so
that it cannot be pulled off easily or tipped over.
This stand is available from your local PROSCAN dealer.
This itemis not avMlable by mail order. To.locate your
nearest PROSCAN dealer, call this toll-free mimber: 1-800-
PROSCAN.
Caution: If you choose not to use the recommended stand
for your TV receiver, take precautions that the stand or
other furniture on which the "IV is placed is properly
located and of adequate strength to prevent the TV from
being tipped over accidently or pulled off the stand.
Tipping the TV over or pulling it off the Stand could Cause.
both damage to the set and personal injury.
3. Connectantenna or cable-TV system.
/ /' AMIA
/ --I _
Incoming Cable ANt B
from Antenna
or
Cpble-W Sys em _
COnVErTeR
Attach power cord.
First attach the flat end of the power cord completely into
the connector on the back of your TV, and then plug the
other end into a wall outlet.
Be sure to insert the plug completely.
Do This Not This
5 Install batteries in remote control.
Details are on page 4.
6 Turn on TV, adjust the volume, and select a channel.
utton
CHANNEL
VOLUME
To turn on the TV, press the iv
button on the master remote or press the POWER button
on the simple remote. When using either remote,
remember to point it at the front of the TV.
Press the VOLUME up or down button to adjust the
volume to a desired level.
Press the cHANNELUp or down button to select the next
channel in memory. Y.'_ucan also press two number
buttons to select a channel..Channels 2-13 and 91 were
programmed into the ch_nel memory at the factory, so
pressing CHANNEL up or down stops at these channels
only. When you start the autoprogramming.feature
(described next), your set will automatically scan
through all channels and place the active channels for
your area into its channel memory.
Most antenna or cable-TV systems can be connected as
shown here.
• Details for connecting a home antenna to your TV are on
page 36.
• Details for connecting
a cabh,-TV system to your TV are
On pages 37-39.
• Details for connecting a VCR to your TV ai'e oh
pages 41-42.