Programming Channel Memory - ProScan PS20112 Owner's Manual

Programming Channel Memory
The quickest way to program the Channel Memory is
to use the AUTOPROGRAM function. Your TV
automatically cycles through and places active
channels into Channel Memory.
li][i_S]
Follow the instructions below to autoprogram channels,
then add or erase individual channels as desired.
AutoProgrammingChannelsinto ChannelMemory
with or without remote
1 Connect home antenna(s) or cable-TV to your set.
2 Repeatedly press the MENU button to select SETUP
MENU
and press + to display the setup functions.
3 Repeatedly press the MENUbutton until the
AUTOPROGRAM
menu is selected.
The TV first programs _Jl channels for ANTA input and
then all channels for ANTB input (even with one antenna
input connected).
il0EI,1
in m
When the TV finishes cycling, you can check the channels
are in memory by pressing the CHANNELup or down
button. Your set will stop on each of the channels in
memory.
Your TV will remember which channels are in memory
until you erase them or until you autoprogram channels
again. Extended power failures have no effect on the
channel memory.
Set _,_,,,,_ _ "_"o ,,
"Chanl.nbel _ '
"tmanCld:.N6m_-
i._l_ (l]l]|eIell_l I
Press either + or - to begin programming. The TV will
cycle thru avail_ple channels in your area and place active
channels into memory.
Ko]L_,, ill=
15