ProScan PS20112 Owner's Manual page 36

m\e,_A,n,t e n na_C_o n:ne c t i o n s
Follow one of the steps below to connect an indoor or outdoor antenna to your TV if you do not ha vea cable-TV system.
A. if your home antenna cable is a 75-ohm, round, coaxial cable that carries only VHF (channels 2-13),
only UHF (channels 14-69), or VHF and UHF channels, connect it to your set like this:
Incoming Cable ___
from Home
Antenna
Back of"IV
CABLE / ANTENNA
ANT A
-J
ANT B
3,
CONVERTER
B.
If your home antenna cable is a 300-ohm, flat, twin-lead cable that carries only VHF (channels 2-13),
only UHF (channels 14-69), or VHF and UHF channels, connect it to your set like this:
Incoming Cable
from Home
Antenna
Adapter (supplied)
(such as 1939831
Push on
Back of "IV
CABLE/ANTENNA
ANT A
ANT B
3,
.3
CONVERTER
C° if your home antenna cable(s) are a 75-ohm, round, coaxial cable that carries VHF (channels 2-13) and a 300-ohm, fiat, twin-
lead cable for UHF (channels 14-69), connect it to your set like this:
Incoming
Cables from
Home
Antenna(sl
Back of 'IV
UHF _ _ _ ANTA
and
ANT B
I VHF _ _ (such as #1975511* 3'
CONVERTER
D° if the antenna cables coming from your home antenna(s) are two 300-ohm, flat, twin-lead cables as shown here, connect
them to your set like this:
Incoming
Cables from
Home
Antenna(s)
Back of "IV.
_i _ _ _--_ CABLE/ANTENNA
UHF "--
ANTA
Pushon
and ANT B
.3,
VHF
3:
Antenna Mixer CONVERTER
(such as #193984)*
*Optional accessory available from your dealer or electronics supply store.
Mail order form is on page 29.
Note: Be sure to connect the UHF antenna cable to the
UHF screws on the Antenna Mixer and the VHF antenna
cable to the screws marked VHF.
32