Margin Mode - Kyocera TASKalfa 620 Operation Manual

Copying Functions

Margin Mode

You can shift the original image to make space on the copy for binding on the left (right) or top
(bottom) side. The supported margin width is as follows.
Margin Width
Inch models
Metric models
Margin on the Back Side
When duplexing, you can also specify the margin on the back side.
Auto - When [Auto] is specified, the left and right margins on the front are reversed on the back. For
example, if the left margin on the front is 1/2" (10 mm), the right margin on the back will be 1/2"
(10 mm). The top and bottom margin widths on the back will match those on the front.
Separate Front/Back Margins - Enables you to specify the front and back settings separately.
NOTE: You can set the default margin width. Refer to Default Margin on page 3-15 for details.
Follow the steps as below to use the Margin mode.
1 Place the originals in the document processor or on the platen with the top edge facing either the
rear or the left side of the copier.
2
Press [Function].
3 Press [Margin/Centering]
([Margin/Imag.Shift]).
4
Press [Margin].
5 Use [ ], [ ], [ ] and [ ] to specify the
margins.
6 When duplexing, press [Back page margin].
1-18
0 to 3/4" (in 1/8" increments)
0 to 18 mm (in 1-mm increments)
Ready to copy.
Paper
Selection
Density
Original
Image
Collate/
Offset
Basic
Ready to copy.
Margin/Centering
Off
Margin
Centering
Ready to copy.
Margin/Centering
Off
Margin
Centering
Original
Duplex Combine
Size
Mixed Size Continuous
Zoom
Originals Scan
Margin/ Form
Page #
Centering Overlay
Border
Booklet
Cover
Erase
User choice Program
Function
Shortcut
Reposition image to left /right or
top/bottom, and also center image
on paper.
Shortcut
Front page
(0 3 / )
4
"
(0 3 / )
4
Left
"
Back page
margin
Paper Size
11x8
100%
Up
Down
Paper Size
11x8
100%
Back
Paper Size
11x8
100%
Back
Select Original
Orientation.
Auto
Top Edge
Top