Chapter 5 Functions; Margin Mode - Kyocera KM-1530 Instruction Handbook Manual

CHAPTER 5 FUNCTIONS

1. Margin mode

The image of the original is shifted to the right to make a margin for
binding on the left side of the paper. The margin width can be
selected from 1/4", 3/8", 1/2", 5/8" and 3/4".
* The margin mode requires the optional memory board.
* The initial value of margin width can be selected from the above.
(See "Margin width" on page 6-6.)
1
To change the margin width, press and hold the Margin key
for 3 seconds. "F17" appears on the copy quantity display
and, 2 seconds later, a number appears. If you do not wish to
change the margin width, proceed to step 4.
The number displayed indicates the margin width as follows:
1: 1/4"
2: 3/8"
3: 1/2"
4: 5/8"
5: 3/4"
5-1
2
Press the Zoom (+) or Zoom (-) key and change the number
to select the margin width.
3
Press the enter key or Margin key. The number of copies
appears on the display. The margin mode is now selected.
4
Set the original(s).
* Set the originals so that the top (left) side of the original is
positioned at the rear side. Setting them in the wrong
direction may cause the margin to appear in the incorrect
position.