3Fusingrollerthermistor/Thermostat/Temperaturefuseremoval - Epson EPL-N2700 Service Manual

EPSON EPL-N2700 / N2750
4.2.21.3 Fusing Roller Thermistor / Thermostat / Temperature Fuse Removal
1. Remove the Fuser Unit. (See Section 4.2.21.1.)
2. Release the joint for the Fuser Unit Cover and the Fusing Roller
Heater Lamp Front Cover.
3. Remove one screw (3501) securing the Fusing Roller Heater Lamp
Front Cover to the Fuser Unit Frame Assembly, and remove the
Fusing Roller Heater Lamp Front Cover. (See Section 4.2.21.2.)
4. Remove one E-ring (9107) and one tension spring securing the
lever to the rear part of the Fuser Unit, and remove the lever.
Figure 4-40. Lever Removal
5. Release the thermistor harness and paper eject sensor harness
from the clamps in the Fusing Roller Heater Lamp Rear Cover.
6. Remove one screw (3501) securing the Fusing Roller Heater Lamp
Rear Cover to the User Unit Frame Assembly, and remove the
Fusing Roller Lamp rear Cover.
Disassembly/Assembly
Figure 4-41. Fusing Roller Heater lamp Rear Cover Removal
7. Remove two screws (1305) securing the Fusing Roller Heater Lamp
Holder to the Fuser Unit Frame Assembly, and remove the Fusing
Roller Heater Lamp Holder.
8. Pull out the Heater Lamp.
Figure 4-42. Fusing Roller Heater Lamp Holder Removal
Disassembly Procedure
Revision B
125