Base Frame Assembly Removal - Epson Stylus Color 1520 Service Manual

&2/25
EPSON Stylus 1520

3.2.10.10 Base Frame Assembly Removal

1. Remove the printer mechanism unit. (Refer to Section 3.2.6.)
2. Remove the paper eject frame. (Refer to Section 3.2.10.7.)
3. Remove the CR unit. (Refer to Section 3.2.10.9.)
4. Remove 1 E-ring mounting the gear (46) and compression spring (1.96) to the left frame assembly. Then
remove the gear along with 2 plain washers and the compression spring.
;
Be careful not to lose the compression spring. It might spring out when you remove the E-ring.
5. Remove the tractor release cam.
6. Adjusting the sub tractor release cam with the cutout in the left frame assembly, and remove it from the
tractor release shaft. (Refer to the figure below.)
7. Remove 5 screws (CBS, 3X6) securing the base frame assembly to the printer mechanism unit, then lift
up the base frame assembly and remove it.
Tractor Release Shaft
Sub Tractor Release Cam
Screws (CBS 3X6)
Plain Washer
E-ring
3-26
WORK POINT
Middle Frame Assembly
Base Frame Assembly
Tractor Release Cam
Gear 46
Compression Spring 1.95
Figure 3-24. Base Frame Assembly Removal
Screws (CBS 3X6)
Right Frame Assembly
Left Frame Assembly
PF Roller Shaft