Canon CLC 1120 Service Manual page 495

CHAPTER 11 INSTALLATION
d) To change to card input,
When 'MANAGE=ID' has appeared,
press '1', and then press 'ENT'.
MANAGE=CARD' appears.
Caution:
1. If bit 4 of the DIP switch (SW5-4) on
the copy data controller is set to OFF,
group control is disabled, and an
exclamation mark will appear (Figure
11-617).
2. If the copier's memory has been used
for ID input, the stored ID numbers
may be used as ID numbers for the
copy data controller.
Work as follows:
Drawing up the ID Numbers
a) Set the DIP switch (SW1) on the coyy
data controller as shown in the table.
b) Press the switch (SW4) on the copy
data controller.
In response, LED5 will turn on
momentarily.
c) LED5 will turn on when data has been
drawn.
If the attempt fails, LED5 will flash; if
this is the case, press the switch (SW4)
once again, and make sure that LED5
has turned on.
The copier cannot discharge paper
while data is being drawn.
11-40
COPYRIGHT © 1999 CANON INC.
Code
SW1
CANON CLC1120/1130/1150 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
Input method
1 Card
2 ID
Table 11-602
Figure 11-617
Bit Position
1,2
3
Table 11-603
ON
OFF