Removing The Transfer Drum Assembly/Transfer Drum Frame; Removing The Transfer Drum - Canon CLC 1120 Service Manual

CHAPTER 7 PICK-UP / FEEDING SYSTEM
A. Removing the Transfer
Drum Assembly/Transfer
Drum Frame

1. Removing the Transfer Drum

Caution:
The one-way clutch is in operation while
the transfer drum is on the transfer drum
frame. Do not rotate the transfer drum
while keeping your fingers in an opening
of the transfer drum.
The transfer drum, on the other hand,
will rotate in reverse when it is off the
frame. Keep this in mid. (Allowing it to
rotate in reverse can damage the transfer
blade, attraction brush, and transfer
drum side scraper.)
1) Open the hopper, and remove the transfer
drum frame cover; then, slide out the
transfer drum frame.
2) Disconnect the separation sensor
connector [1], three transfer drum
connectors [2], and polishing roller motor
connector [3].
7-74
COPYRIGHT © 1999 CANON INC. CANON CLC1120/1130/1150 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
[1]
Figure 7-801
[2]
[3]
Figure 7-802