CHAPTER 9 EXTERNALS / AUXILIARY MECHANISMS
Caution:
When mounting the editor control PCB,
be sure to match the ON/OFF notations
of the switches [1] and [2] on the PCB by
referring to the switch settings indicated
on the flat cable.
2. Removing the Editor Mirror
1) Remove the six face plates for screws.
2) Remove the two screws (M8x8), six
screws (M8x10), and six screws (M8x28),
a total of 14 screws; then, detach the
copyboard cover.
3) Remove the two screws, and detach the
controller PCB cover.
4) Remove the flat cable [1], and five screws
[2]; then, remove the controller PCB
support plate [3].
5) Remove the mirror plate [4].
9-24
COPYRIGHT © 1999 CANON INC.
[1]
[2]
CANON CLC1120/1130/1150 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
[2]
[1]
Figure 9-718
[3]
[2]
Figure 9-719
[4]