Canon CLC 1120 Service Manual page 489

A: If the Communication Control Board-
A1 or the Interface Board-B1 is to be
connected (requires the Power
Supply-A1),
B: If the Communication Control Board-
A1 or the Interface Board-B1 is not to
be connected (does not require the
Power Supply-A1),
2. Installing to the Copier
When installing the copy data controller
to the copier, keep the following in mind:
1. Be sure to comply with the laws and
regulations of the country.
2. Be sure that the copier has been
properly installed.
3. Be sure that the copier's power plug is
disconnected.
4. Be sure to identify the screws by type
(length, diameter) and location.
5. Be sure to prepare settings data on the
computer at the service station (if
remote control is planned).
1) Remove the four screws [2], and detach
the face plate [1] of the copier's rear cover.
COPYRIGHT © 1999 CANON INC. CANON CLC1120/1130/1150 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 11 INSTALLATION
JB2 JB1
Figure 11-604
Figure 11-605
[1]
[2]
[2]
Figure 11-606
JA1
JA2
11-35